Planmeca ProSensor HD can be installed via USB or IP Ethernet. You check if the sensor is installed by launching Didapi Configuration (from windows search) and going to Prosensor>Ethernet Settings>Ping.
If the ping has a response, install the sensor in Muntra by:
1. Open Muntra offline-app, login and go to "den här datorn" under the settings icon in the top right corner.
2. Hover over "Planmeca PMC" and open the settings. Configure the following settings:
Source: Planmeca ProSensor Size 2
Type: DIDAPI
Enable: Add to menu
Enable: Reactivate after scanning
3. Reload the Muntra offline app
If DIDAPI is not installed:
1. Download Planmeca Imaging package
2. Run the setup.exe under DIDAPIKIT_STANDALONE
3. Click through the wizard/installer without makeing any corrections. I.e. click "next" and "install".
4. Complete the installation.
5. Open Didapi Configuration
6. Enter the sensors IP adress under Prosensor>Ethernet Settings.
7. Click 'Ping' to verify the IP adress
8. Open Muntra offline-app, login and go to "den här datorn" under the settings icon in the top right corner.
9. Add "Planmeca PMC" by selecting "lägg till i meny"
10. Reload the Muntra offline app
