Planmeca ProOne via Ethernet. You check if the sensor is installed by launching Didapi Configuration (from windows search) and going to ProOne>Ethernet Settings>Ping.
If the ping has a response, install the panorama in Muntra by:
1. Open Muntra offline-app, login and go to "den här datorn" under the settings icon in the top right corner.
2. Hover over "Panorama PoOne" (or ProMax / Dimaxis, depending on your type of panorama) and open the settings. Configure the following settings:
Source: Planmeca ProOne
Type: DIDAPI
Enable: Add to menu
3. Reload the Muntra offline app
If DIDAPI is not installed:
1. Download Planmeca Imaging package
2. Run the setup.exe under DIDAPIKIT_STANDALONE
3. Click through the wizard/installer without makeing any corrections. I.e. click "next" and "install".
4. Complete the installation.
5. Open Didapi Configuration
6. Enter the sensors IP adress under ProOne>Ethernet Settings.
7. Click 'Ping' to verify the IP adress
8. Open Muntra offline-app, login and go to "den här datorn" under the settings icon in the top right corner.
9. Add "Planmeca ProOne" (or ProMax, Dimaxis, depending on your type of panorama) by selecting "Add to menu"
10. Reload the Muntra offline app
